33
190033
BACKING
1” x 3-1/2”
3
PLATE
(2.5 x 8.9 cm)
84
010084
LOCK
1/4”
6
WASHER
(.6 cm)
85
010085
HEX NUT
1/4”
6
(.6 cm)
143
190143
ELEMENT TO
3-1/2” x 1-3/8”
3
BOOM CLAMP
(8.9 x 3.5 cm)
402
010402
U-BOLT
1/4” -20 x 1-3/4”
3
55”
29-1/2”
#3
#1
4 - ELEMENT MOUNTING
Attach the elements to the boom assembly as shown in Figure 4. Attach
element #1 to the end of the boom at 36 inches from the mast clamp.
Locate the element next to the black plastic cap. Using the U-bolt (402),
element to boom clamp (143), backing plate (33), lock washers (84), and
hex nuts (85), fasten the element to the boom. The exposed threads on
the element screws (item 31 from section 2) should be facing down and
away from the boom.
Attach element #2 to the boom at a distance of 29.5 inches (74.9 cm)
from element #1. Using the U-bolt (402), element to boom clamp (143),
backing plate (33), lock washers (84), and hex nuts (85), fasten the
element to the boom. Note that the exposed threads on the element
screws (item 31 from section 2) should be facing away from the boom.
Attach element #3 to the boom at a distance of 55 inches (139.7 cm)
from element #2. Using the U-bolt (402), element to boom clamp (143),
backing plate (33), lock washers (84), and hex nuts (85), fasten the
element to the boom.
Check each X-hat assembly to insure that the rods are located at 45
degrees relative to the boom. If the rods are not at 45 degrees, loosen
the appropriate worm clamps and rotate the elements to achieve the
correct angle. If necessary, rotate the trap bodies to align the drain holes
facing downwards. Tighten all worm clamps once the X-hat rods and
traps have been rotated to the correct position.
KEY P/N DISPLAY DESC SIZE QTY
SEE FIGURE 4C
SEE FIGURE 4A
FIGURE 4
(139.7 cm)
(74.9 cm)
ELEMENT #3
ELEMENT #1
#2
SEE FIGURE 4B
ELEMENT #2
Page 7
MA5B