Curtiss-Wright | PG Drives Technology
SK77981-14
90 | R-net Technical Manual | Chapter 3 – Programming
CONTROLS – SPEED PADDLES
7.36
SPEED PADDLE OPERATI ON
This sets whether speed adjustment is via a momentary or continuous operation of the CJSM2’s Speed Paddle.
The programmable options are Momentary and Continuous.
If set to Momentary, the speed setting change occurs upon the initial deflection, rather than on the release) the Speed Paddle
will adjust the speed setting by the programmed value of parameter Speed Step Size.
If set to Continuous, while the Speed Paddle is held deflected the speed setti ng will change by the programmed value of
parameter Speed Step Size at a rate defined by the programmed value of parameter Speed Step Rate.
7.37
SPEED STEP SIZE
This sets by how much the speed setting will change when the CJSM2’s Speed Paddle is operated.
The programmable range is 1% to 80% in steps of 1%.
The term operation is defined by the programmed setting of parameter Speed Paddle Operation.
If that parameter is set to Momentary, then an operation is a single deflection of the Speed Paddle.
If that parameter is set to Continuous, then an operation is a continuous deflection of the Speed Paddle for the programmed
value of parameter Speed Step Rate, and will auto-repeat.
7.38
SPEED STEP RATE
This sets the rate at which speed setting changes occur when the Speed Paddle is deflected.
The programmable range is 0.02 to 5.00 seconds in steps of 0.02 seconds.
This parameter is only effective when parameter Speed Paddle Operation is set to Continuous.
7.39
SPEED WRAP TIME
This sets a time delay between the s peed setting wrapping from maximum to minimum. The purpose is to prevent inadvertent
wraps, i.e. the user accidentally ‘overshooting’ the maximum speed setting.
The programmable range is 0 to 30 seconds in steps of 1 second. :If set to 0, then no wrapping will occur.
7.40
SPEED WRAP DELAY
This sets a time delay after a wrap before the speed setting increases from the minimum level.
The programmable range is 1 to 10 seconds in steps of 0.5 seconds.
7.41
SPEED WRAP BEEP
This sets whether there is an audible beep when the CJSM2’s speed setting wraps from maximum to minimum.
The programmable options are Yes and No.
