Curtiss-Wright | EL30 Rev. H PN23942 6/14/16
12
FSB Installation/Replacement:
1. Using proper sized gland or spanner wrench, remove existing FSB
from actuator face plate, and slide off the actuator rod. This will
require the removal of any rod attachments. One source for gland
wrenches is Martin Fluid Power.
http://www.mfpseals.com/seal_repair_kits/parker-2.shtml
Exlar Actuator
Model
Martin Fluid
Power Part No.
Size
(in)
Description
EL30
PH-0695900000
1/2, 5/8
Rod Gland
Wrench
2. Remove the o-ring from the 0-ring grove located inside the opening
from which the FSB was just removed.
3. Replace the o-ring with the o-ring
supplied with the new FSB.
4. Taking care not to touch the seal
material to any sharp rod features
such as threads, slide the FSB on to
the actuator rod and to the face
plate.
5. Using the appropriate gland and
spanner wrench, tighten the FSB to
the proper torque level indicated in
the previous
table.
5.0 SYSTEM INSTALLATION
This section provides you with cable and wiring information for
operation of your EL Series actuator with Exlar’s SV Series Digital
Positioner. (NOTE: If you use a different amplifier, contact Exlar for
assistance.)
EL Series
Actuator
Inertia
lb-in-s
2
EL30-03xx
0.00319
EL30-06xx
0.00361
EL30-10xx
0.00416
EL30-14xx
0.00473
EL30-18xx
0.00533
