![background image](http://html1.mh-extra.com/html/curtis/ru-series/ru-series_user-manual_2699208013.webp)
Cleaning the Faucet and Sight Gauge - As Needed
The following cleaning process requires a mild solution of dish-washing
detergent and warm water, and One-Pro Beverage Equipment Cleaner
(Curtis PN WC-79001). Mix the One-Pro cleaner at a ratio of 1 oz. (28 g.)
per 5 gal. (19 L) of hot water (122°F/50°C min.).
1 Unscrew the handle/bonnet assembly and remove. Inspect the seat
cup for wear. Replace the seat cup if it is damaged.
2
Remove the hose on top of the gauge (if applicable) by pulling it
up and off of the cap. Remove the gauge cap and the glass tube.
Inspect the glass tube for cracks or chips.
3
Wash
- Wash the faucet and gauge parts in the detergent solution.
Clean the glass tube with a gauge brush soaked with the detergent
solution.
4
Rinse
- Thoroughly rinse all parts with clean, warm water.
5
Sanitize
- After rinsing, place the faucet and gauge parts in One-
1SPTPMVUJPONJYFEBTTQFDJmFEBCPWFBOEBMMPXUIFNUPTPBLGPS
15 minutes.
6
Air Dry
- Remove the parts from the sanitizer, rinse thoroughly
and allow them to air dry.
7 Reassemble - When dry, reassemble the handle/bonnet. Hand
tighten the handle/bonnet onto the top of the faucet assembly.
Reassemble the gauge.
CLEANING INSTRUCTIONS
CI18
'"6$&5("6(&$-&"/*/(*/4536$5*0/4ø
A
Seat cup
Faucet
Handle
Bonnet
Faucet Disassembly
Shield
Washer
Washer
Glass
Hose*
* Hose used only on models with aeration feature
Sight Glass Disassembly
Cap
&RQ¿JXUDWLRQ
varies
WASH
RINSE
SANITIZE
WARNING
- If the gauge glass is broken, carefully inspect and
remove all traces of glass and insert a new glass tube, then
thoroughly rinse out the faucet shank.