E-<3>
POWER SOURCES
AC ADAPTER OPERATION
To use the adaptor, plug the small round end of the adaptor into the DC
jack (12). Then plug the pronged plug into AC wall outlet.
WARNING:
Before plugging into AC wall outlet, make sure the outside adapter voltage selector is
set for the voltage used in your location.
Use other adapter with wrong specification may damage your set.
12V CAR/BOAT ADAPTER OPERATION (not supplied)
Plug the torpedo-shaped end of the adapter into the socket, making sure to push it all
the way in. Now plug the small end of the adapter into the DC jack (12).
The set will now operate on the current of your Car/Boat power source.
IMPORTANT
: DC adapter operates only with a negative ground battery system. If you
are not certain your vehicle operates on a 12-volt DC, negative-ground system, consult
your vehicle’s user manual.
BATTERY OPERATION
Open the battery cover (8), then install TEN 1.5V “C” size batteries (not supplied) into
the compartment and close the case. Be sure negative and positive terminals are
positioned as indicated in the battery compartment.
When either of the above mentioned adapter is plugged into the unit, the power from the
batteries is automatically disconnected.
CAUTION:
Do not mix batteries of different composition or old with new batteries.
Do not mix alkaline or standard (carbon zinc) with rechargeable (nickel cadmium)
batteries.
TO CHARGE NI-CD BATTERIES
Set the function selector (19) to the “Charge” position. Insert the AC adaptor plug into
the DC input jack. Charging time takes about 12 hours.
NOTE
: when batteries have been fully charged, the function selector (19) must be
changed to other position or unplug the AC adaptor.
1. Do not charge alkaline batteries as charging will cause these batteries to leak acid or
explode.
2. Charge only NI-CD batteries.
3. Use only the AC adaptor included in your set.
