13
Timer
Setting the timer
Switching the timer off
1.Press the timer button to switch the
timer off.TIMER will disappear from the
display.
1.Press the TIMER button to turn the timer
function on,TIMER will flash on and off for
a short time.
2.While timer is flashing on the display,
hold the PROG/MEMORY button down
for 3 seconds and then release.The
display will show the time with the hours
flashing on and off.
3.Use the TRACK/TUNE buttons to select
the hour and press PROG/MEMORY.
The hour stops flashing and the minutes
start flashing.
4.Use either of the TRACK/TUNE buttons
to select the minutes and press the
PROG/MEMORY button.
The timer is now set.TIMER will flash
on and off for a few seconds then the
display will revert to the previous mode.
Sleep Function
Your CD micro system can be set to switch
off automatically after a preset period of
between 10 and 90 minutes.
1.While the unit is on,press the SLEEP
button on the remote control.The
display will show 90 and SLEEP will
flash on and off.This indicates that the
system will switch off in 90 minutes.
2.Successive pressing of the SLEEP
button reduces the time by 10 minutes
with each press.For example if you
want the system to switch off in 30
minutes press the SLEEP button seven
times.
3.After approximately five seconds the
sleep tunction is registered.The display
reverts to its previous state,SLEEP
stops flashing and remains on.
Note: You have approximately five seconds
between successive pressings of the
SLEEP button before the sleep]
function is registered.
4.Toremove the sleep setting press the
SLEEP button again.SLEEP will be
removed from the display.
