P - 5
Power Sources
Battery installation (remote control
unit)
Note: When start to operate the handset, please pull out
the insulation plate directly.
1.
Remove the battery cover.
2.
Insert one battery (CR 2025) making sure the polarity
(+ / –) matches the marks inside the unit.
3.
Replace the cover.
Do not attempt to recharge, short-circuit, disassemble,
heat or throw the batteries into the fire.
Charging the Battery
After loading the battery, then refer the step of “Using AC
Adapter for player” to connect power converter.
Notes:
• For the kind of Ni-MH rechargeable battery, it will not be
fully charged when a battery to be charged first time,
please note that the discharging time will be short.
• The battery will be operated normally with normal capacity
after 4~5 times of charging and discharging. It is not a
defect and abnormal battery.
• After a period of storage, or not use for a period, it will
require users to repeat above mentioned steps to get the
battery back to normal condition.
• The battery is fully charged for approximately 4 hours
after the AC adaptor is connected.
Battery is charging the CHARGE indicator at the front will
light on RED. When charging is completed, the FULL indi-
cator will light on GREEN.
Notes:
• Disconnect the AC adapter plugs from both the battery
and the AC outlet, when charging is completed or not
necessary.
• Battery recharge circuit operates in OFF mode. Switch
off the unit for battery recharge.
• When battery is fully charge and released from unit, the
CHARGE indicator will light on RED, it means the charge
circuit is ON
Battery Low Indication
When using the rechargeable battery to playing and the
battery is nearly exhausted, the player front “STANDBY”
indicator will blinking. In a while, the power will be turned off
automatically. Refer “Charging the Battery” to recharge
the battery.
Using the Car Adapter
Plug the small end of the car adapter into the DC IN jack
and then plug the other end into the cigarette lighter socket.
This indicator lights when the power is on.
Battery installation (player)
Following the diagrams below, to loading or release the
battery.
Note: When release the battery, then push down and hold
the lock on backside, put back to release.
Using AC Adapter for Player
Insert the DC plug at the end of the adapter cord into the DC
IN jack at the right side of the player. Then plug the other end
into an AC wall outlet.
Notes:
•
Only use with the supplied AC adapter. Using with
other AC adapter could be damaged.
•
Remove both DC plug & AC-IN plug, to disconnect
the AC adapter when not necessary.
610 CURTIS eng A5 ib.p65
5/3/2006, 3:31 PM
5
Black
