![background image](http://html.mh-extra.com/html/curtis/1kb33as/1kb33as_installation-and-owners-manual_2700218002.webp)
DESIGN CONCEPT
Curtis cabs feature an assembly of parts designed for your vehicle which require
adjustment and alignment of components to accommodate vehicle variations and
provide proper weather protection. For accurate installation, proper operation, and
years of satisfaction, please read and understand the installation instructions.
From all of us at Curtis, we thank you for choosing our product.
CAB INSTALLATION
BEFORE YOU START
HELPFUL HINTS:
A.
Refer to parts diagram toward the back of this manual
to help identify parts during the assembly process.
B. To assist with the cab installation, leave all bolts
loose for later adjustment unless otherwise specified.
C. Read and understand all instructions before beginning.
D. Plastic washers have been supplied to provide a
weather seal under the heads of all exterior bolts.
The plastic washer should be installed under each
bolt head directly against the outside cab surface.
Care should be taken not to over tighten the fast
-
eners and damage the plastic washer. Also use
steel washers as required. See diagram.
E. Apply a silicone sealant to seal any minor
gaps that may occur due to vehicle variations.
F.
Use caution to avoid damaging the factory installed
threaded inserts. Begin the bolt engagement by hand
to avoid or correct potential cross threading.
TOOLS REQUIRED
driver and passenger.
Curtis accessory weights are listed in product
add additional weight to the base vehicle. All
Curtis Cabs, blades and general accessories
ADDED
WEIGHT
brochures. Deduct the accessory's total weight
from the vehicle's rated capacity and never
exceed the vehicle's rated capacity including
Exposure to Carbon Monoxide can Cause
illness, serious injury or death.
Never
operate vehicle if suspicious of Carbon Monoxide. Inspect
exhaust system for leaks monthly. Leaks can result from loose
connections, corrosion, cracks or other damage to the exhaust
manifold. If leaks are found, repair or replace exhaust system.
Do not use vehicle until repair or replacement is complete.
p. 2 of 12
Fastener
Cab Surface
Steel Washer
Plastic Washer
Set of standard and metric sockets
Set of standard and metric open end wrenches
Drill
3/8" drill bit
Measuring Tape
Clamp
One Phillips Head Screwdriver
Scissors
One
3/8”
Drive Ratchet
One
5/32”
Allen Wrench (preferably
“
T
”
handle type)
One
3/16”
Allen Wrench (preferably
“
T
”
handle type)