C. Wiring the new controller:
1.
Using the three 13mm bolts retained when the
original controller was removed, securely fasten
the four large diameter wires to the new
controller.
C from motor and CB+ from solenoid.
A1 from motor
CB- from battery
2.
The new controller uses ring terminals instead
of faston connectors for the field connections.
Using a wire crimper and the two ring terminals
(included) cut and re-crimp the black and white
10awg wires coming from the motor.
3.
Using the supplied M6 bolts, washers, and
lock washers secure the field terminals to the
new controller. The white cable gets
connected to the F1 connection the black
cable to the F2 connection.
4.
Insert the conversion harness into the new
controllers 6 and 24 pin connectors.
5.
Connect the 16 pin conversion harness
plug and 16 pin original wire harness plug.
62-EZHB-AO WORK INSTRUCTIONS REV. 02 9/14/2018
