PAGE 7
•
51160-INS-RB
•
877.287.8634
•
NEED ASSISTANCE?
•
CURTMFG.COM
Brakes activated, flashing
Reconnect - Recalibration needed,
unplug and replug trailer connector
Calibrating
Overload - Output circuit,
trailer brake system fault
Low Volt - Tow vehicle system
Blank display, standby mode,
illuminates when control is activated
Not Connected - Standby mode,
no trailer connected
Connected - Standby mode,
trailer connected
Startup / Calibration screen
Gain - Output adjustment
Load - Sensitivity adjustment
Error - Accelerometer error,
powers brakes using default values
Short - Stoplight wire (red)
shorted to ground
Blank display, does not illuminate when
control is activated, check installation
Disconnect - Flashing, trailer
disconnected, off after 60 seconds
OLED Display
The OLED display shows the output setting when the control is activated. It is used to set
up and monitor the brake controller and can be used when troubleshooting.
