58963-INS-RB
•
PAGE 4
Step 13
Secure any excess wire so that it is not drooping or dangling, but not so tight that
it causes unnecessary strain to the wire which could lead to breakage over time.
After removing slack from the 4-flat wire, tighten any zip ties and add as needed.
Use a zip tie to fasten any excess wire to a solid spot along the driver-side inner fender.
Reinstall all items removed during install. If it was disconnected at the beginning of the installation,
reconnect the negative battery terminal. Install the provided 4-flat dust cover to help prevent corrosion.
Step 10
Route the 4-flat wire under the skid plate
and along the brake lines until you
reach the rear of the front tire.
Use the provided zip ties as
needed to secure any loose wire.
Step 11
From the driver-side engine compartment, use
the fish wire between the inner fender and the
exterior fender to route the 4-flat up to the
engine compartment. Locate the end of the fish
wire just behind the inner fender/ wheel well,
and attach to the fish wire and pull to the top
side of the engine compartment.
Step 12
Route the 4-flat along the driver side outer
fender. Be sure to route under the two fender
mounts. Route the 4-flat under the plastic
shroud covering the driver-side front head
lights. Mount to the front core support between
the windshield washer fluid reservoir and the
coolant reservoir.
