58963-INS-RB
•
PAGE 2
Step 2
Open the rear door of the vehicle. Use a
Torx T-27 bit to loosen the two screws
securing the taillight in place. Remove
the taillight by pulling straight back.
Separate the connectors, taking
care not to damage the locking
tabs. Set the taillight aside.
Repeat on the other
side of the vehicle.
Step 4 - How to use fish wire
A)
Fish wire is a way to push or pull
an electrical wire through a blind hole.
Make sure the wire is long enough
to stick out on the other side.
Insert the fish wire through the blind
hole and locate it on the other side.
B)
Use tape to secure the harness
to the fish wire and pull back up.
The fish wire or harness may get hung up on
something, if this happens you may have to
push back down, wiggle it around or twist the
wire to loosen it from what it’s hung up on.
Fish wire could be anything from a cut-up wire
hanger, stiff wire, rope or string depending on
what is needed for the installation.
Step 3
Starting on the driver side, run a fish wire down
between the body and the bumper cover. From
under the vehicle locate the side of the custom
RV harness with the yellow wire. Attach the
yellow wire to the fish wire and pull the
harness up to the factory harness.
Step 1
Locate the vehicle battery. Look up the
battery location in the owner's manual of
your vehicle. Disconnect the negative battery
terminal. Be sure to fasten this wire down
and away from the battery when completing
the installation process.
A
B
A
B
