58957-INS-RA
•
05/29/2020
•
PAGE 4
Step 11
Route the 4-flat up to the rear of the front
tire. From the engine compartment under the
hood, on the driver's side, run a fishwire down
between the inner and outer fender. The wire
will come out at the back of the front tire.
Step 12
Route the wire between the body and the
engine mount. Attach to the fishwire and pull
the 4-flat up into the engine compartment.
Route the 4-flat along the driver side front
fender to an accessible mounting location
in front of the vehicle.
Step 10
Route the 4-flat of the RV harness from the
rear of the vehicle, over the top of the rear
drive-line suspension, along the body frame
to the back of the front tire. Use zip ties to
secure the harness in place.
Do not tighten, allowing for later adjustment.
Step 13
Pull all of the excess wire so that it is not loose. Do not pull it too tight, this can cause unnecessary strain on
the wire and could cause a breakage over time. After removing all slack from the 4-flat wire, tighten any cable
ties and add as needed. Use a cable tie to fasten any excess wire to a solid spot along the driver's side inner fender.
Reinstall all items removed during install. If it was disconnected at the beginning of the installation,
reconnect the negative battery terminal. Install the provided 4-flat dust cover to help prevent corrosion.