GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
2000
200
28
30
KIA SOUL
9/16/2015
11419
60
Scan
for more
information
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HEX BOLT
M10 - 1.25 x 30
6
1
CONICAL TOOTHED WASHER
7/16"
6
2
TOOLS REQUIRED
PHILLIPS SCREWDRIVER
FLAT BLADE SCREWDRIVER
10mm AND 17mm SOCKETS
12" EXTENSION
RATCHET
TORQUE WRENCH
1. Remove the splash shields and liners in both rear wheel wells by removing the (4) push fasteners
and (6) screws securing them. Gently seperate the wheel well liner from the fender well to allow for hitch installation.
2. Lower the exhaust by removing the (1) rearmost rubber isolator from the hanger. (See Rubber Isolator Removal Diagram.)
3. Optional - For ease of install - Remove the (3) nuts securing the canister at the driver side frame rail using 10mm
socket. Use a small screwdriver on the spring clips to remove canister from frame. Carefully suspend canister
during hitch installation.
4. Raise the hitch into position and align the holes in the side plates with the holes in the sides of the frame rails. Secure the
hitch with 7/16" conical toothed washers and M10 hex bolts into each weldnut.
Torque all M10 hex bolts to 48 ft-lbs.
5. Raise exhaust back into postion and secure to vehicle hanger.
If Step 3 was executed: Raise canister back into postion and reattach useing factory hardware.
6. Reinstall the splash shields into the wheel wells. Trimming of drivers wheel well may be required around driver side plate.
Installation Complete
DESIGNED FOR USE
WITH EURO BALLMOUNT
45571 (1 7/8") BALL AND
45572 (2") BALL
DESIGNED FOR USE WITH
BALL MOUNT #45521/D-21
- NO DRILLING
- LOWER EXHAUST
2
1
Summary of Contents for 11419
Page 4: ......
