Currys Essentials CCHOBKN13, Instruction & Installation Manual, Page: 8 / 16

8
Preparing the Worktop
Cut out the work surface following the dimensions shown in the drawing below.
• For the purpose of installation and use, a minimum distance of 5cm space must be left around the cut out.
• Be sure the thickness of the work surface is at least 20mm. Use a heat-resistant work surface material to avoid
deformation caused by the heat from the hob. The minimum distance between the hob and the cupboard
should be at least 65cm.
Cut-out Dimensions
The dimensions of the cut-out are shown in the diagram.
Product Overall Dimensions
Width: 590mm Depth: 520mm
Fitting the Hob into the Worktop
1. Turn the hob upside down and place it on a soft surface.
2. Apply the single-sided self adhesive sealing tape (supplied)
to the underside of the outer edge of the glass ceramic
panel. Ensure the sealing tape is not stretched.
3. Screw the worktop mounting brackets into
the side walls of the panel as shown.
4. Insert the appliance into the aperture.
490
mm
560
mm
* All images are for indication only; please refer to your individual unit for actual item.
• The hob must be installed by qualified personnel or technicians.
• The hob should not be mounted above cooling equipment, dishwashers and rotary dryers.
• All surfaces around the hob should be able to withstand the heat generated by the hob.
• Never use a steam cleaner to clean the hob.
• Do not use a silicon sealant to seal the appliance against the aperture. This will make it difficult to
remove the hob from the aperture, particularly if it needs to be serviced.
All measurements given in millimetres (mm)
and cutout dimensions are given as:
‘nominal measurement’
CCHOBKN13_IB.indd 8 12/04/2013 12:12