Cuppone PZF/30, Use And Maintenance Manual

Page: 23 / 30

23
DISPLAYED MESSAGE PROBABLE CAUSES SOLUTIONS FOR THE USER
The displays show
“Err”
and
“rOt”
because the motor
does not complete an ascent and a descent within the set
time.
The dough is not completely ripened or it is too cold
Check that the dough has ripened.
Check the temperature of the dough, it must not be too cold.
Minimum recommended temperature 10° - 12°C (50°F - 54°F)
The plate preparation procedure has not been carried
out (cleaning, oiling and starch release) Clean, oil and carry out the starch releasing procedure on the plates
(see page
14
)
The pressed dough is too thin
Increase the thickness of the dough acting on the
flattening adjustment
lever
Foreign bodies between the plates or non-compliant
use of the appliance
Check that there are no foreign bodies between the plates and the appliance
is used as expected. To bring the plate to the starting position, do not force
it, switch the machine off and on again and start a new cycle by lowering the
protective grille.
The top or bottom display shows
“Err”.
Alarm message: a problem has occurred that prevents
the appliance from operating normally.
Contact the service centre.
The top display shows
“Err”
and the bottom shows
“rES”
or
“rEI”
.
Alarm message: a problem has occurred that prevents
the appliance from operating normally.
Contact the service centre.
The top display shows
“Err”
and the bottom shows
“rEF”
.
Alarm message: a problem has occurred that prevents
the appliance from operating normally.
Contact the service centre.
The displays show
“PiF 197”
The appliance has been stopped pressing the
emergency button
To reset the conditions of use, unlock the emergency button rotating it in a
clockwise direction:
the display will show “PIF 197”
which is NOT an alarm
but stands for the board version.
Power was disconnected and e reconnected to the
appliance
“PIF 197”
is NOT an alarm, it is the board version.
Ed. 0121 - 70702572 REV03 Pizzaform - Use and maintenance