Cuppone Donatello KDN 435, Pre-Installation And Installation Manual

Page: 23 / 28

23
Ed. 0221 - 70702730 REV03 Donatello hood - Pre-installation - Installation
D
P
K
1
2
2
3
1
fig.9.
from the hood
Installation
Fig.9.
The electrical connection must be carried out
exclu-
sively
by qualified personnel after reading the safety
warnings at the beginning of the manual.
Before connecting the hood
check that the systems
the oven is connected to comply with the current
regulations
in the country of use.
Pass the hood cable with the connector K through the hole
you took the cap off previously T .
Block the cable with the locknut D .
Plug the hood connector K into the socket P in the oven
electrical panel.
If required, the cable can be replaced by the Dealer or its
technical service or by a person with similar qualifica-
tions, to prevent any risk.
Installed cable type:
H07rN-f three-pole cable for single-phase cabling
Installed cable section:
3x1 mm
2
silicone cable