d) Place the squeezer in a site where it
cannot be affected by a direct stream of
water and where foreign objects cannot
penetrate the interior of the machine.
e) Keep the squeezer away from the heat
sources such as a radiator or fan duct,
and keep away from direct sunlight, exces-
sive dust, rain, mechanical vibrations or
impacts.
f) To avoid internal overheating, place the
squeezer in a properly ventilated site.
The squeezer’s electrical connections and
wiring must be made by qualified per-
sonnel, always following these safety indi-
cations:
a) Make sure the electrical data on the
nameplate (see section 7 of this manual)
match the mains power.
b) The squeezer must be connected to
a grounded mains outlet meeting your
country’s safety requirements. The
non-fulfilment of this requeriment cons-
titutes a serious hazard to your health.
The manufacturer cannot be held respon-
sible in the event of injuries or damages
caused by a lack of proper grounding of
the facility.
c) The electrical system of the site where
the squeezer is installed should be protec-
ted with a magnetothermal switch suited
to the power absorbed by the squeezer as
indicated on the nameplate (see section 7
of this manual).
d) A differential really suited to the facility’s
10
Electrical Wiring
09
Locating the Squeezer
20cm
20cm
20cm
30cm
20cm
characteristics must be supplied.
e) Make sure that the section of the facility’s
wiring is appropiate for the intensity consu-
med by the machine.
f) Do not use extension cords, adapters
or multiple plugs when connecting the
squeezer to the mains.
g) If the cord is damaged, it must be
substituded by the manufacturer or the
after-sales service or qualified person-
nel, in order to avoid any danger.
