Cumberland PNEG-240, Installation And Operation Manual

Page: 24 / 76

6. Installation
24 PNEG-240 Chain Feeding System
Installing the Trough, Couplers and Corners (Continued)
Insert the other end of trough (D) into a coupler (G) then add the next piece of trough until reaching the
first corner.
(See Figure 6F.)
Figure 6F
When inserting the trough into the corners, make certain that the trough is inserted completely into the
corner. Continue to assemble the balance of the circuit until reaching the incoming side of the hopper.
IMPORTANT: Make sure that the trough (D) is inserted behind the trough stop (H). (See Figure 6G.)
Figure 6G
When the need arises to shorten a standard length of trough, squarely cut the trough to the dimensions
below.
(See Figure 6H.)
Figure 6H
Ref # Description
D Trough
G Coupler
Ref # Description
D Trough
H Trough Stop
Ref # Description
I 2-5/8" (6.67 cm)
J 2-1/2" (6.35 cm)