12
PNEG-620-2
Curtain Controller
5. Pulley Cover Mounting
Pulley Cover Mounting Instructions
Attaching Pulley Covers to Pre-Existing Cable
NOTE: If you do not have pre-existing cable, drill a 1/4" hole in the appropriate dimple and proceed to
.
Step 1:
Determine on which side of the machine the pulley cover will be mounted. This will affect where
the slot will be cut in
Step 2:
Using a saw, cut a slot from the bottom of the pulley cover lip to the dimple on the cover’s face.
When slotting the right pulley cover, use the right dimple for placement. When slotting the left
pulley cover, use the left dimple for placement. (
for slot placement.)
Figure 5A
Step 3:
Slide the existing cable into the slot until it reaches the dimple.
Step 4:
Remove existing sheet metal screw. (
for pulley cover fastening.)
Figure 5B
Step 5:
Fasten the pulley cover to the machine using four (4) #10-16 x 5/8" sheet metal screws. The top
of the pulley cover should be flush with the top of the machine.
Summary of Contents for CC2415
