2. Safety
PNEG-250-PM
Hi-Lo and PRO-1 Pan Feeder Parts
9
Dust
Under normal working conditions, the Pan Feeder System should create little or no dust hazard. However,
some feed materials may create dust when being moved. This dust may be harmful to your health if
inhaled. Seek advice from your feed supplier and use a suitable dust mask as needed.
Noise
Tests on this machine indicate noise levels at a position 1 meter from the drive unit, 1.6 meters above
the ground do not exceed 70 dBa, continuous ‘A’ weighted sound pressure or 63 Pa, instantaneous ‘C’
weighted sound pressure.
Use Caution in the Operation of this Equipment
The design and manufacture of the Pan Feeding System is directed toward operator safety. However,
the very nature of a Pan Feeding System requiring electrical power and possessing moving parts does
present a hazard to personnel which cannot be completely safeguarded against without interfering with
efficient operation and reasonable access to components.
Continued safe, dependable operation of automatic equipment depends, to a great degree, upon the
owner/operator. For a safe and dependable Pan Feeding System, follow the recommendations within this
manual and make it a practice to regularly inspect the operation of the unit for any developing problems
or unsafe conditions.
READ THESE INSTRUCTIONS BEFORE OPERATION AND SERVICE
SAVE FOR FUTURE REFERENCE
1. Read and understand the operating manual before trying to install or operate the Pan
Feeding System.
2. Power supply should be OFF for service of electrical components. Use CAUTION in checking voltage
or other procedures requiring power to be ON.
3. Never attempt to operate the Pan Feeding System by jumping or otherwise bypassing any safety
devices on the unit.
4. Keep the Pan Feeding System clean. Do not allow debris to collect around drive unit, control pan,
hoppers or boots.
5. Use CAUTION in working around the Pan Feeding System’s moving parts.
This product is intended for the use of feed handling only. Any other use is considered a misuse of
the product.
Some edges of the product’s components are sharp. Examine each product component to determine if
there are any safety considerations to be taken prior to use and/or installation. Any and all necessary
personal protective equipment should be worn at all times when handling, assembling, installing and
operation of the product and/or its components.
Throughout this manual, guards are removed for illustration purposes only. All guards must be in place
before and during operation.
For guidance or assistance on any issues relating to the safe use of Pan Feeder System,
Contact:
Cumberland
1004 E. Illinois St.
Assumption, IL. 62510
Phone: 1-217-226-4421
