Culligan Smart Filter Arsenic Reduction Water Conditioner, Owner'S Manual

Page: 19 / 27

19
If the words “
PROBLEM FOUND
” appear on the main screen, it indicates that there are one
or more errors detected. Pushing the “
CHECKMARK
” button will display the first error present.
Pressing the DOWN arrow will show any additional errors present. At the bottom of this list the
user can “ CLEAR THE ERROR ” or “ EXIT ”. Pressing the “ CHECKMARK ” button on the “ CLEAR
THE ERROR
” message causes the controller to re-check to see if the error condition still exists, if it
still exists, the error will remain displayed on the main screen. If the error no longer exists the main
menu will return to displaying “
SYSTEM OK
”.
error
description
Reason for error Comment/ Clearing error Message
No Remote
RF
Signal
Main board is not receiving a
signal from the remote
Remote is off, out of range or on a different channel from the main
board. If interference is suspected, try moving the remote closer or
switching to a different channel on both the main and remote units
Motor
Position
Error
Motor did not move when it
should. No feedback from
switches
Use manual motor control to see if motor is actually working and not
jammed. Use Diagnostics/ Sensor menu to verify that the optical or
mechanical position switches are working
Replace
Filter
Media
Total gallons thru the unit has
exceeded the specified capacity
of the media
Replace the media. Reset the media filter life at Main Menu/
Advanced Setup/Regen Settings/ Media Life
Call Culligan at
xxx-xxx-xxxx
This message is displayed if an
error has been detected that
requires servicing and
no modem installed in the
system
Call the number shown. If possible, place this call using a phone
that will allow you to see and enter changes to the main controller if
required by the service technician during the call
Position Sensor
Error
The motor is turning, but the
position sensor appears to be
incorrect
Check the motor using manual motor control and the position
sensors using Main Menu/ Advanced/ Diagnostics Sensors
Low Battery Battery needs replacement Replace with Panasonic Model# CR 2032 3V battery.
Error Codes