94
Culligan® Premier Series Automatic Deionizer
94
Cat. No. 01024000
Auxiliary External Outputs
Up to three programmable auxiliary outputs can be added to the Premier AutoDI by using an optional output block (P/N
01023675). Install the output module in the control box as shown in
(Optional: 120VAC) 1 Amp signals that can be used to drive solenoid valves or relays to control valves, pumps, or mixers
to control the discharge of acidic and caustic waste from a neutralization holding tank. For example, the outputs can be
used to control a neutralization system.
During regeneration, the cation and anion tanks each empty acidic and caustic waste into a neutralization holding tank. It
is important to make sure both tanks have enough time to empty in equal amounts in order to create a pH-neutral waste
flow. The ON DELAY setting specifies the minutes after regeneration begins that the system waits before opening the
discharge (drain) valve on the neutralization holding tank. The ON TIME setting specifies the number of minutes the valve
will remain open—enough time to completely empty the tank.
When using external 24VAC or 120VAC solenoid valves, connect one wire to either the Aux6, Aux7, or Aux8 output as
. Connect the other wire to Terminal Block 9 or Terminal Block 17.
Time
To
tal
Ta
nk V
olum
e
On Time: tank
valve is open
for the specified
cycle and time
On Delay: tank valve is closed
while regeneration directs acidic
and caustic waste liquids into
holding tank
Start of
Specified
Cycle
Acidic Waste Out To
Neutralizing Hold Tank
Caustic Waste Out To
Neutralizing Hold Tank
Water In
Figure 41.
Control of external neutralization tank(s).
SERVICE 1
STANDBY 2
FEB-01-13 12:11P
1. From the default home screen, press
to display the main menu.
1)INFORMATION
2)MANUAL REGEN
3)SET DATE/TIME
>4)ADV. SETUP
2. From the main menu screen, press
to 4) ADV. SETUP.
3. Press
. The screen displays the Advanced Setup menu.
2)REGEN SETUP
3)CYCLE TIMES
>4)AUXOUT SETUP
5)MODEM SETUP
4. Press
and
to select 4) AUXOUT SETUP. The screen displays the op-
tion of changing the settings of AUX 6, AUX 7, and AUX 8.
