WATER LINE IN
AUXILLIARY
WATER OUT
Install regulator if water
pressure exceeds 100 PSI
WATER
CONNECTIONS
Figure 1
Figure 2
6
Your new water dispenser features a water bottle cap with siphon tube that can accommodate various size bottles up
to 5 gallons (19 liters) water bottle.
The water bottle cap and siphon tube assembly is shipped in it’s default configuration for use with a standard 5 gallon
(19 liter) bottle. For proper operation, make sure the collar of the water bottle cap is seated securely to the neck of the
bottle. (Fig. 1)
To adjust the siphon tube length, hold the siphon tube cap and pull the stainless steel tube up or down. (Fig. 2)
Continue to the OPERATION step.
Your cooler can be used with a direct water line connection and filtration system. The filtration system can be installed
prior to the water dispenser or can be installed inside the cabinet behind the door.
ADJUSTING THE SIPHON TUBE FOR SMALLER BOTTLES
PREPARING THE WATER SYSTEM FOR USE AS A BOTTLE-LESS (DIRECT TO WATER LINE
CONNECT) WATER DISPENSER
To connect to a water line, locate the inlet on the rear of
the unit and remove the plug from the push-to-connect
fitting marked “Water Line In”.
WATER TUBE CONNECTION/
DISCONNECTION PROCEDURES
Fig. A
NOTE: Do not use water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system
1. To connect, push tube
through collet ring into body.
2. Tube must sit fully past
o-ring.
3. To disconnect, hold collet
ring against body and pull
tube out.
