4
PREPARATION
Ü
Set the unit on a flat surface.
Ü
Insert the supporter arm into the stand.
Ü
Adjust the supporter arm to the appropriate height;
inserting the screw to hold the desired height in place.
Ü
Install the bulbs with the appropriate wattage rating,
as indicated on the warmer.
OPERATION
Ü
Plug cord into a grounded electrical outlet of
the correct voltage. Electrical shock can occur
if the appliance is not grounded.
Ü
For best results, place food products in a pan
located directly under the bulbs.
Ü
Turn unit off when not in use.
Ü
To disconnect the appliance, turn the switch off
and remove the plug from the power source.
CLEANING
NOTE: Proper maintenance plays an important part in the life span and functioning of the warmer.
Ü
Unplug the cord and let the warmer cool before cleaning or moving.
Ü
Clean with a damp sponge and mild soap. Rinse with clean water and wipe dry.
Ü
Do not immerse in water or other liquids.
MAINTENANCE
Bulb Replacement
NOTE: Each standard heat lamp is suitable for use with clear or infrared heat lamp bulbs rated at or
below 250 watts.
Ü
To replace a bulb, place the switch in the OFF position and allow the bulb to cool completely.
Ü
Bulbs have a threaded base; unscrew the bulb counterclockwise from the unit and replace
with a new bulb.
FOR SAFE
&
PROPER OPERATION
,
DO NOT INSTALL A BULB BEYOND
250
WATTS INTO THE UNIT
.
DISPOSAL OF EQUIPMENT
To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle equipment responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer where the
product was purchased.
