![CULITEK MBD-2428 Instruction Manual Download Page 9](http://html1.mh-extra.com/html/culitek/mbd-2428/mbd-2428_instruction-manual_2697705009.webp)
MANUAL
Beer Dispensers
SYMPTOM
CORRECTIVE ACTION
Fuse blown or circuit breaker tripped
Replace fuse or reset circuit breaker
Power cord unplugged
Plug in power cord
Thermostat is set at wrong temperature setting
Dial Controls: Set to higher number
Digital Controls: Set to lower number
Cabinet in defrost cycle
Wait for defrost cycle to finish
SYMPTOM
CORRECTIVE ACTION
Excessive amount of warm product
placed in cabinet
Allow adequate time for product to cool down
Prolonged door opening or door ajar. Ensure
doors are closed when not in use.
Avoid opening doors for long periods of time
Door gasket(s) not sealing properly. Ensure
gaskets are snapped in completely.
Remove gasket and wash with soap and water.
Check condition of gasket and replace if necessary.
Dirty condenser coil
Clean the condenser coil
Evaporator coil iced over
Unplug the unit and allow coil to defrost.
Make sure thermostat is not set too cold.
Ensure that door gasket(s) are sealing properly.
SYMPTOM
CORRECTIVE ACTION
Thermostat is at wrong temperature setting
Digital Controls: Set to lower number
Air flow is blocked
Re-arrange products to allow for proper air flow.
Make sure there is at least four inches of
clearance from the evaporator.
Excessive amount of warm product placed in
cabinet
Allow adequate time for product to cool down
Dirty condenser coil
Clean the condenser coil
Prolonged door opening
Ensure doors are closed when not in use.
Avoid opening doors for long periods of time.
Evaporator coil iced over
Unplug the unit and allow coil to defrost.
Make sure thermostat is not set too cold.
Ensure that door gasket(s) are sealing properly.
TROUBLESHOOTING
Compressor is Not ruNNiNg:
CoNdeNsiNg uNite ruNs for LoNg periods of time:
CabiNet temperature is too Warm: