21
2. The hob shall not be mounted to cooling equipment, dishwashers and rotary
dryers.
3. The hob shall be installed such that better heat radiation can be ensured to
enhance its reliability.
4. The wall and induced heating zone above the work surface shall withstand
heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to
heat.
6. A steam cleaner is not to be used.
7. This ceramic can be connected only to a supply with system impedance no
more than 0.427 ohm. In case necessary, please consult your supply authority
for system impedance information.
Connecting the hob to the mains power supply
The power supply should be connected in
compliance with the relevant standard, or a
single-pole circuit breaker. The method of
connection is shown as the diagram.
1. If the cable is damaged or needs replacing, this should be done by an after-
sales technician using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed with a minimum gap of 3mm between the
contacts.
3. The installer must ensure that the correct electrical connection has been made
and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a proper qualified
person.
