Cuizimate RBSCORNDOGMAKER, Instruction Manual, Page: 10 / 13

appliance into water. Avoid water
running into the appliance.
-If the mains cord of this appliance is
damaged, it must only be replaced by
their service representative, as special
tools and/or parts are required.
-This appliance is not intended for use
by person(including children) with
reduced physical, sensory or mental
capabilities or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
-Children should be supervised to
ensure that they do not play with the
appliance.
Before using for the first time.
-Clean the baking plates with a damp
cloth or sponge.
-Slightly grease the baking plates
with a little butter or cooking oil.
-Plug in the Hotdog waffle maker
and heat up the plates until the green
Ready to cook pilot light goes on.
-The Hotdog waffle maker is ready
for use
Note:
when using this Hotdog waffle
maker for the first time, a fine smoke
haze may result. This is normal because
of the initial heating of the internal
components.
-Put the mains plug into the wall
socket. The red power light will
illuminate to show that the Hotdog
waffle maker is heating.
-Prepare the corndog and filling for your
Hotdog waffle maker is pre-heating.
-Wait until the green on pilot light gets
on. , the Hotdog waffle maker is then
at the correct temperature for use.
-To obtain an even golden brown
result, you can slightly butter the side
of the corndog, Place your filling in
Hotdog waffle maker green indicator
will turn of.
-Open the Hotdog waffle maker
after 3-5 minutes and check whether
corndog is sufficiently ‘brown’. The
cooking time.Remove corndog from
Hotdog waffle maker.
-Do not use sharp or abrasive kitchen
utensils.
-Unplug the Hotdog waffle maker
from the wall socket after use.
Note:
During cooking, the green
ready to cook pilot light cycles on and
off to maintain the appliance at the
correct temperature.
Operating Instruction
9