OPERATING TIPS:
• Your Pellet Grill should never be moved while it is hot. If you are transporting your grill in a vehicle after
cooking on it, make sure the fi re is completely out and the grill is cold before placing it in any vehicle.
NEVER put water into the fi re pot. It will jam the auger and can damage the ignitor.
• The Pellet Grill is designed to operate with the lid closed.
• Make sure the heat baffle is properly seated on its locating brackets. The opening of the heat baffle
should be pointing left over the fi re pot. If not seated properly, direct heat and fl ame could come up out
of the fi re pot and cause a grease fi re or grill damage.
• The temperature readout is an approximate and can be affected by the following factors: outside
ambient temperature, the amount and direction of wind, the quality of pellet fuel being used, the lid
being opened, and the quantity of food.
•
When selecting a temperature setting, the auger will feed pellets for several minutes. This will
momentarily raise the temperature, but the temperature will decrease and stabilize after 10-15 minutes.
•
The auger will not run 100% of the time, it cycles on and off depending on the temperature setting.
•
Hot weather can cause the temp to drop very slowly and make it more difficult to cook at lower settings.
•
Pellets can hang up in the pellet hopper after cooking for a long period of time. It’s important to monitor
the pellet level and mix the pellets by hand to ensure they fl ow into the auger.
•
Ash Clean-Out:
Before each use, open ash clean-out to get rid of ash and burnt pellets.
1. Lift Ash Clean-Out Handle Lock
2. Pull Ash Clean-Out Handle to open ash door.
Note: Make sure Ash Cup is in place before emptying ash.
•
Pellet Hopper Clean-Out:
If grill will be left un-attended for a long period of time, we recommend
you remove unused pellets. Always store wood pellets away from heat
and in a dry location.
1. Lift Clean-Out Handle Lock
2. Open Hopper Clean-Out door.
Note: Make sure to hold a pail or bag in place before emptying
pellets.
•
Meat Probes:
Plug the meat probe into the pellet control panel as shown. You can read the temperature of
Probe 1 at the bottom of the display screen.
Example: “P1:86” — means Probe 1’s temperature is 86 degrees Fahrenheit.
8
888
228
888 888
888
86
250
TEMP
Easy Connect BBQ
•
Bluetooth App:
1. Your grill is Bluetooth capable.
2. This Bluetooth app allows you to monitor the internal grill
temperature as well as two meat probe temperatures.
3. The Bluetooth range is around 120 ft and can vary with
obstructions such as interior and exterior walls.
