7
you allow it to flow, the
lighter it will be.
Press to start
dispensing. When your
cup is filled to desired
level, press again to stop.
PROGRAMMING A
CUSTOM SETTING
At ready mode, press and hold
MANUAL for 3 seconds to
customize the SHORT
and LONG output.
1.
, , are ON. If no
action within 30 seconds,
unit returns to preheat/
ready mode.
2. Press or button.
a. or and LED remains on.
b. Espresso is dispensed.
c. When desired amount is dispensed into
cup, press
or
again. That will be
the programmed amount.
d. If no action during dispensing within
90 seconds, unit returns to preheat/
ready mode.
To reset to factory setting at
ready mode, press and hold
and at the same time
for 3 seconds.
1. ,and and LEDS
flash 3 times.
2. Default setting is on and unit will return to
preheat/ready mode.
STEAM
1. Remove the
milk tank by
holding the
milk tank and cover, and pull away from the
machine. Remove the cover and pour milk
into the tank, above min. fill line (5 ounces)
but not exceeding the max. fill line (22
ounces). Replace the cover and align the milk
tank to the connector on the side of the
machine, and push in to install. Place a mug
on the drip tray and position the steam wand
into the mug. Adjust the length of the stainless
steel cover on the wand so it is the proper
length for your mug. Press the STEAM
button to start steaming, and use the steam
control dial to control the air/foam. Press
again to stop steaming.
NOTE
: Turning the steam control dial to the right
creates more froth.
2. To remove the steam wand, position it pointing
straight down, then rotate counter clock wise
and pull straight out.
NOTE
: For best results cleaning the milk tank,
please follow these instructions: Remove the milk
tank by holding the tank and cover and pull aw ay
from the machine. Remove the cover and pour
water into the tank. Replace the cover, align the
milk tank to the connector on the side of the
machine, and push to install. Place a mug on the
drip tray and position the steam wand into the
mug. Adjust the length of the stainless steel cover
on the wand so it is the proper length for your
mug. Press the steam button to start steaming
water through the tank and wand to clean. Press
the steam button again to stop steaming before
your mug is full with water. Follow by
disassembling all of the removable parts, and wash
by hand or place in the dishwasher.
CAPPUCCINO or LATTE
1. Using the lever, open the brew head, insert a
capsule, and close the brew head.
2. Be sure there is milk in the
milk tank and tank is properly
installed (see steam section).
3. Place a mug on the drip tray,
and position the steam wand
in the mug.
4. Use the steam control dial to
select the amount of air/froth
you want.
