Cuisinart EM-400 SERIES illy, Instruction/Recipe Booklet

Page: 8 / 20

7
2. With a coffee cup or mug on the drip tray,
select COFFEE (approximately 6 ounces).
(The coffee setting and, if applicable, the
temperature setting LEDs remain on, while all
the other LEDs are off. Once all LEDs are on
again, the machine is ready for the next
cycle.)
CAUTION: Scalding may occur if the brewing
head is opened during brewing cycle.
Reminder: There is no need to rinse in-between
cycles as there will be no transfer of flavor. See
Espresso section NOTE on previous page.
Manual/Adjustable Strength Control
1. Using the lever, open the brew head, insert a
capsule, and close the brew head.
2. For adjustable strength
control, use the MANUAL
button to adjust the length
of time espresso or coffee
is dispensing – the longer
you allow it to flow, the
lighter it will be.
Press to start dispensing. When your
cup is filled to desired level, press again
to stop. Manual function will time-out after
90 seconds.
PROGRAMMING
A CUSTOM SETTING
At ready mode, press and hold MANUAL
for 3 seconds to customize the SHORT ,
LONG and COFFEE output.
1. , , are flashing and is ON. If no
action is taken within 30 seconds, unit
returns to preheat/ready mode.
2. Press , or button.
a. Chosen setting and LEDs remain on.
b. Espresso/coffee is dispensed.
c. When desired amount is dispensed into
cup, press chosen setting again to stop.
That will be the programmed amount and
unit will return to preheat/ready mode.
d. If no action is taken during dispensing
within 90 seconds, unit returns to preheat/
ready mode. Setting will not be changed.
To reset any setting to factory default (at ready
mode), press and hold and chosen setting at
the same time for 3 seconds.
1.
or or and LEDs flash 3 times.
2. Default setting is on and unit will return to
preheat/ready mode.
TEMPERATURE
CONTROLS
Extra-hot is the default setting. If hot is
desired, press and hold the button for 3
seconds to allow the temperature to decrease.
The flashing light will turn off when it has
reached the lower temperature.
ENERGY-SAVER MODE
After 30 minutes of non-use the espresso
machine will automatically switch to sleep
mode and all the control lights will be dimmed
by about 50%. When any button is pressed,
the espresso machine will return to preheat
mode and all the lights will flash. The machine
is ready to operate when all the lights are
steady again.
AUTO-OFF MODE
Following the 30-minute
Energy Saver cycle, if
there is an additional 30
minutes of non-use, the
espresso machine will
turn off. Press the
power button to turn on
again.