Cuckoo CRP-HF06 Fuzzy Series, Operating Instructions Manual

Page: 8 / 52

When the cooker is not properly cleaned, it can cause smells. Clean the top cover frequently.
If there are any rice or alien substances on the oven packing or on the inner side of the inner pot,
it can cause the steam to leak. Therefore the rice may be under-cooked and crumbly.
Don t use to be used
for various
purpose for inner pot.
Check if there is any rice or alien
substance on the oven packing.
Make sure you clean the steam
control vent before and after use
Wipe the main unit with a wet cloth
that has been squeezed out of all the
water
It can cause the transformation of
inner pot. It can cause to spill the
inner coating
Wipe the top cover with a wet
cloth that has been squeezed
out of all the water
If there is any alien substance
on the temperature sensor
carefully wipe it out without
damaging the metal plate
The valve hole of the pressure weight allowing the escape of steam should be checked regularly to ensure
that it is not blocked.
If you use the valve hole of pressure weight as it is blocked, the hot steam or any hot content within the
cooker can cause injury.
Do not use a Cleaning Pin for other use except cleaning for the valve hole of the pressure weight.
Do not try to close the top cover by force. It can cause problems.
When opening/closing the top cover.
1. Locate the handles of the inner pot
on the slot of the main unit.
(Refer to the following figure.)
2. Open and close the top cover with
the Lock/Unlock handle located on
Unlock .
When cooking/warming the rice.
Cook and warm the rice with the
Lock/Unlock handle located on “Lock”.
When steam is full inside the pan, the
Lock/Unlock handle will not turn at this
time twist the pressure weight and let the
steam out.
How to
disassemble
the pressure
weight
If the valve hole of the pressure weight part is clogged, punch it with the cleaning pin.
Under the Lock/Unlock handle is locked (located on "Lock") turn the pressure weight
counter-clockwise while pulling it up, and pull it out.
Punch the clogged valve hole with the cleaning pin and reassemble it by turning it clockwise.
When the pressure weight is properly assembled, it can freely be turned.
Attached on the bottom
of the unit.
Pressure Weight
Soft steam cap
Alien Substance
Cleaning Pin