8
| RV BLIND SPOT DETECTION SYSTEM: For Motorhomes
RV BLIND SPOT DETECTION SYSTEM: For Motorhomes |
9
English
Installation Guide
Controller HMI CAN TX Failed
Radar System Error
Sleep Mode
System Initialization
Do Re Mi
Do Re Mi
1 second beep, stop .5 second & 1 second beep
3 second beep
STATUS
SOUND
ISSUE
POSSIBLE CAUSE
POSSIBLE SOLUTION
The system does not
respond after starting
the engine
The indicator does not
light up
The buzzer makes no
sound
The power switch
does not work
[ Do Re Mi ]
alarm
Radar disconnection or
no OBD connection
IGN lead connected
to constant power
Did not enter sleep
mode after 5 minutes of
IGN off
Power On
Self-test
System
Operation
Functions
Incorrect connection or
control unit failure
Damaged indicator
Damaged buzzer
Contact your dealer
Contact your dealer
Contact your dealer
Abnormal power supply,
wiring, or radar, please
contact your dealer
Disconnected indicator
Disconnected buzzer
Damaged power switch
Disconnected power
switch
Confirm that the IGN,
wiring, fuse, and
controller are connected
No Level 1 BSD alert
No Level 2 BSD alert
No RCTA alert
Vehicle speed is less
than 12 mph
Bad connection from
OBDII
Turn signal leads not
connected
Reverse lead not
connected
Normal operation.
The vehicle is not compatible.
Please contact the dealer
Confirm turn signal leads are
connected
Confirm that the reverse lead
is connected
SYMPTOM
Verify connection
Verify connection, press and
hold the switch for 2 seconds
Change the IGN to a switched
power source connection
location
Press the RESET button on
the control unit after starting
the engine. Check the system
again after the reboot is
completed.
Verify connection
6. ERROR DIAGNOSTICS
It is possible that the Blind Spot Detection System will trigger an alert even though there is
no vehicle in the blind spot zone. The Blind Spot Detection System can detect objects such
as: construction barrels, guard rails, lamp posts, etc. Occasional false alerts are normal.
