Cub Cadet CC924HT, Operator'S Manual, Page: 8 / 16

-8-
STARTING
WARNING
Before starting the engine, keep the cutting
attachment clear of everything around it.
WARNING
Exhaust gases contain carbon monoxide, a
colorless, odorless,poisonous gas. Do not
operate the engine in enclosed areas. Provide
adequate ventilation at all time.
1. Use the mixing tank to mix the fuel and oil.
Fill fuel tank with the mixture. See “Fuel and Oil
Instructions”.
2. Push the ignition switch to the “Run” positon.
3. Make sure throttle lockout and throttle trigger at
the released position.
Run
Ignition Switch
Stop
Throttle Trigger
Throttle Lockout
4. Fully press and release the primmer bulb for 10
times. Some amount of fuel should be visible
in the primer bulb and fuel lines.
Primmer Bulb
5. Move choke lever to the position.
6. When the engine is already warm or on hot
days, set the choke lever to the position.
7. Put the machine on flat ground,make sure the
cutting attachment is clear of everything
around it.Hold the unit with your left hand and
press it against the ground.While holding the
starter handle in right hand. Gently pull the
starter rope out until you feel that the pawls
hook onto the flywheel, and then pull the
starter quickly.
Choke Lever
Idle screw
Carburetor
Run Position
Start Position
8. Repeat several times until the engine starts.
9. After starting the engine, run the engine at
the idling speed for a few minutes.
10.After the engine is warmed up appropriately
press throttle lockout and throttle trigger, then
choke lever will be back to the run position
automatically.
WARNING
Releasing the starting rope suddenly may allow
the rope to whip around and cause injury and/or
damage to the recoil starting mechanism. When
starting engine,firmly grasp the recoil starter
grip; do not grasp the starter rope itself. Always
control the rope as it rewinds into the housing.
1.If the engine fails to start, do not try to
pull the recoil starter too many times with
the choke lever to the position. Just
press down the throttle lockout and
squeeze the throttle trigger to switch the
choke lever to the position, and then
release the throttle triggle back. Repeat to
pull the recoil starter grip until the engine
starts.
2.After starting the engine, run the engine at
the idling speed for a few minutes.
OPERATING INSTRUCTIONS