![background image](http://html.mh-extra.com/html/cub-cadet/cc5075/cc5075_operators-manual_2694292008.webp)
8
CHECKING THE OIL LEVEL
The importance of checking and maintaining the proper oil level
in the crankcase cannot be overemphasized. Check oil before
each use:
1.
Stop the engine and allow oil to drain into the crankcase.
2.
Place the engine on a flat, level surface with the cutting
head shield hanging off a work bench or table to get a
proper oil level reading (Fig. 18).
3.
Keep dirt, grass clippings and other debris out of the engine.
Clean the area around the dipstick before removing it.
4.
Remove the oil fill plug.
5.
Look into the oil fill hole, use a flashlight if needed. The oil
should be just touching the inner most thread (Fig. 19).
6.
If the oil level is not touching the inner most thread on the
oil fill hole, add a small amount of oil to the oil fill hole and
recheck (Fig. 19). Repeat this procedure until the oil level
reaches the inner most thread on the oil fill hole.
NOTE:
Do not overfill the unit.
NOTE:
Make sure the O-ring is in place on the oil fill plug when
checking and changing the oil (Fig. 20).
Fig. 18
Oil Fill Plug
Oil Fill Hole
O-Ring
MaxOil Fill Line
Fig. 20
Fig. 19
MAINTENANCE AND REPAIR INSTRUCTIONS
LINE INSTALLATION
Always use original equipment
manufacturer 0.105 inch (2.667 mm)
replacement line. Lines other than
those specified may make the engine
overheat or fail.
To install the trimming line:
1.
Insert each end of the replacement
line into the holes on either side of
retention hook (Fig. 14).
2.
Push the ends through until they
stick out of the sides of the head
(Fig. 15).
3.
Pull the ends through making sure
that the ends are of equal length
and the middle of the line is
centered between the insertion
holes (Fig. 16).
4.
If the ends are not of equal length,
push the longer end back through
the head part way and pull the
shorter end to compensate.
Repeat until both ends are the
same length.
5.
Push the trimmer line behind the
hook to secure it from coming
loose while running (Fig. 17).
WARNING:
Never use metal-reinforced line, wire,
chain, or rope. These can break off and become
dangerous projectiles.
WARNING:
Always use the correct line length when
installing trimming line on the unit.
Fig. 14
Fig. 16
Fig. 15
Fig. 17
Summary of Contents for CC5075
Page 30: ...F14 REMARQUE ...