6
3
Setting Up
Your Snow
Thrower
NOTE: All references
in this manual to the
left or right side of the
snow thrower is from
the operating position
only. Exceptions, if any,
will be specified.
IMPORTANT
This unit is shipped
with the engine full of
oil. After assembly,
refer to the Tecumseh
Engines manual
packed separately with
your snow thrower
for fuel and oil fill-up
details.
IMPORTANT
: Two replacement auger shear pins are
included with this manual (or stowed in the plastic handle
panel). Refer to the Maintenance section for more
information regarding shear pin replacement.
NOTE
: All references in this manual to the left or right
side of the snow thrower is from the operating position
only. Exceptions, if any, will be specified.
IMPORTANT
: This unit is shipped with the engine full of
oil. After assembly, refer to the Tecumseh Engine manual
packed separately with your snow thrower for fuel and oil
fill-up details.
1. a. Remove the lower star knob and carriage bolt from
each side of the lower handle. Pivot the upper
handle upward as shown in Figure 3-1. Align upper
handle with the lower handle. Make certain the
springs at the lower end of the auger and drive
cables are securely hooked into their respective
actuator bracket.
2. a. Secure the upper handle and lower handle with the
two star knobs and carriage bolts removed earlier.
See Figure 3-2.
b. Tighten the two star knobs already installed in the
upper holes to firmly secure the upper handle and
support tubes.
3. a. Remove the flat washer and hairpin clip from the
end of the chute directional control. See Figure 3-3.
b. Insert the end of the chute directional control
into the chute bracket and secure with the flat
washer and hairpin clip just removed. If necessary,
the chute bracket can be adjusted. Refer to the
Adjustments section.
Figure 3-2
Figure 3-1
Figure 3-3
Summary of Contents for 828 SWE
Page 30: ...30 ...
