Recoil Starter
CAUTION!
Do not pull the starter handle while the
engine running.
WARNING:
To avoid unsupervised engine
operation, never leave the machine unattended
with the engine running. Turn the engine off after
use and remove key.
Insert key fully into slot, Figure 5-1. Make sure it snaps into
1.
place. DO NOT turn key. The engine cannot start unless the
key is inserted into ignition switch.
Move throttle control to FAST (rabbit) position.
2.
Move choke to the CHOKE position (cold engine start). If
3.
engine is warm, place choke in RUN position.
Push primer three (3) times, making sure to cover vent hole
4.
when pushing. If engine is warm, push primer only once.
Always cover vent hole when pushing. Cool weather may
require priming to be repeated.
Pull gently on the starter handle until it begins to
5.
resist, then pull quickly and forcefully to overcome the
compression. Do not release the handle and allow it to
snap back. Return rope SLOWLY to original position. If
required, repeat this step.
As the engine warms, slowly rotate the choke control to
6.
RUN position. If the engine falters, restart engine and run
with choke at half-choke position for a short period of time,
and then slowly rotate the choke into RUN position.
Stopping the Engine
WARNING:
To avoid unsupervised engine
operation, never leave the machine unattended
with the engine running. Turn the engine off after
use and remove key.
Run engine for a few minutes before stopping to help dry off any
moisture on the engine.
Move throttle control to STOP position.
1.
Remove the key. Removing the key will reduce the
2.
possibility of unauthorized starting of the engine while
equipment is not in use. Keep the key in a safe place. The
engine cannot start without the key.
Wipe any moisture away from the controls on the engine.
3.
To Engage Drive
With the throttle control in the Fast (rabbit) position, move
1.
shift lever into one of the six forward (F) positions or two
reverse (R) positions. Select a speed appropriate for the
snow conditions and a pace you’re comfortable with.
Squeeze the drive control against the handle the snow
2.
thrower will move. Release it and drive motion will stop.
To Steer
With the drive control engaged, squeeze the right steering
trigger control to turn right. Squeeze the left steering trigger
control to turn left.
CAUTION:
Operate the snow thrower in open areas
and at slow speeds until you are familiar with the
drive control and comfortable operating the
steering controls.
To Engage Augers
To engage the augers and start throwing snow, squeeze the
auger control against the left handle. Release to stop the augers.
Replacing Shear Pins
The augers are secured to the spiral shaft with two shear pins
and cotter pins. If the auger should strike a foreign object or ice
jam, the snow thrower is designed so that the pins may shear. If
the augers will not turn, check to see if the pins have sheared.
See Fig. 5-3.
CAUTION:
NEVER replace the auger shear pins with
anything other than OEM Part No. 738-04124A
replacement shear pins. Any damage to the auger
gearbox or other components as a result of failing to
do so will NOT be covered by your snow thrower’s
warranty.
WARNING!
Always turn off the snow thrower’s
engine and remove the key prior to replacing shear
pins.
Figure 5-3
16
s
ectiOn
5 — O
peratiOn
Summary of Contents for 524 SWE
Page 29: ...Notes 29 12 ...
