Cub Cadet 19A70040100, Operator'S Manual, Page: 9 / 20

9 S
ection
4 — A
SSembly
& i
nStAllAtion
9. Snap the plastic upper chute support in place by first
clipping the side portion onto the bagger support rail (1)
with the edge of the snap feature aligned with the red line,
as seen in the inset of Figure 4-6.
1
2
Figure 4-6
10. Snap the front side of the chute support to the rail (2), as
shown in Figure 4-6.
11. If not already assembled by the factory, install the bagger
screen into the bagger cover by first inserting the end
closest to the center into the cutout mounting hole, as in
Figure 4-7. Make sure to feed the screen under the lip, as in
Figure 4-8.
Figure 4-7
Note: If you decided to leave the hitch support only
finger tight during the assembly process, tighten all of the
hardware securely at this time.
6. Install the bagger upright mounting bracket onto the
mounting assembly (1 in Figure 4-4) of the tractor by
hooking it over the bagger cross-support bracket near the
center, lining up the corresponding mounting hole with
the deck size of the tractor this bagger is being installed on.
See the inset of Figure 4-4.
7. Secure the upright mounting bracket to the mounting
assembly using a 5/16” carriage bolt and flange lock nut
packed in with the upright bracket. See 2 in Figure 4-4.
48-inch 60-inch
54-inch
1
2
2
Figure 4-4
8. Lower the bagger hanger assembly down onto the upright
support bracket, as shown in 3 of Figure 4-5. Secure the
hanger assembly to the upright mounting bracket using
the remaining 5/16” carriage bolt and flange lock nut
packed in with the upright bracket. See 4 in Figure 4-5.
3
4
4
Figure 4-5