Cub Cadet 19A70040100, Operator'S Manual, Page: 8 / 20

Assembly & Installation
4
8
Note: The 712-3010 hex nuts should be tightened (against
bumper if bolts are inside-out, or against bracket if bolts
are outside-in).
3. Install the bagger support frame onto the hex screws
installed in Step 2, and secure with a 712-3004A flange lock
nut from the same hardware pack. See Figure 4-2.
Note: The 712-3004A lock nuts should be left only finger
tight to facilitate the remaining installation steps. You will
be instructed to tighten this hardware later in this manual.
Figure 4-2
4. Install the bagger cross-support bracket with the flange
facing outward, as shown in Figure 4-3, by attaching it to the
side support brackets using four 710-04048 hex screws and
712-3004A flange lock nuts from hardware pack 689-00338.
5. Further secure the bagger cross-support bracket to the
tractor by installing four 710-04043 hex screws through
the cross-support bracket and into the rear of the tractor
frame. Secure using four 712-3004A flange lock nuts from
hardware pack 689-00338. See Figure 4-3.
Figure 4-3
IMPORTANT:
If installing this bagging kit on a ZF-L (lap bar)
unit, bumper adaptor kit 19A70046100 is required and must be
installed prior to attempting to install this bagger. See the retailer
in which you purchased this bagger to purchase this adapter kit.
CAUTION:
Do not attempt to install this bagging
attachment on the tractor while it is still hot from
operation. Do not attempt to install this bagger until
the tractor has fully cooled down.
NOTE: References to left, right, front and rear of the tractor are
from the operator’s position, unless otherwise stated.
•
Before assembly, place the tractor on a firm, level surface,
disengage the PTO, stop the tractor engine and set the
parking brake.
• For convenience, pivot the seat forward and leave it in
that position until the grass collector is fully mounted and
assembled.
Install Mounting Assembly
CAUTION:
Do not attempt to install this bagging
attachment on the tractor while it is still hot from
operation. Do not attempt to install this bagger until
the tractor has fully cooled down.
1. Remove hex screw and flange lock nut shown in Figure 4-1
from the rear frame of the tractor on each side.
Figure 4-1
2. Install a bagger support bracket on each side of the tractor,
by feeding a 710-1090 hex screw found in hardware pack
689-00338 through the frame, then a 712-3010 hex nut.
Tighten the hex nut on each hex screw.
Note: The hex screws can be fed outward through the
frame first, as shown in Figure 4-2, or inward through
the bagger support bracket first. This option is based on
preference.