CTS IPS-3106SFP-DR, User Manual, Page: 10 / 23

10
2. INSTALLATION
To properly install the Managed Industrial PoE Ethernet Switch, please follow the
procedures listed below. Procedures covered in this chapter are described below in
separate sections.

Installation Requirements

Unpacking the Managed Industrial PoE Ethernet Switch

Installing the Managed Industrial PoE Ethernet Switch

Powering on the Managed Industrial PoE Ethernet Switch

Connecting the Managed Industrial PoE Ethernet Switch to the Network
2.1 Installation Requirements
ATTENTION
Be sure to power off before installing or wiring your Managed
Industrial PoE Ethernet Switch.
Be sure to calculate the maximum possible current in each power
wire and common wire. If the current goes above the maximum
ratings, the wiring could overheat, causing serious damage to your
equipment.
Be sure to read and follow below important guidelines :

Do not run signal or communications wiring and power wiring through the
same wire conduit. Wires with different signal characteristics should be
routed separately to avoid interference.

It is recommended that wiring which shares similar electrical characteristics
can be bundled together.

Keep input wiring and output wiring separate and label the wiring to all
devices in the system if necessary.
2.2 Checking the Package Contents
Unpack the package carefully and check the package contents. The package should
contain the following items:

Items included in standard package:

1 Managed Industrial PoE Ethernet Switch

1 Documentation CD