CTI Janus Programmable Automation Controller IOG
53
8.3.2
Network Settings
This page sets the IP parameters for the controller and configures how the embedded switch forwards Ethernet
frames.
•
Primary Subnet Configuration
(configuration is required)
o
Automatic (DHCP): Designates that IP parameters will be assigned using DHCP (Dynamic Host
Configuration Protocol)
o
Static: IP parameters will be entered in the boxes below
•
Alternate Subnet Configuration
enables the controller to communicate on additional IP subnets. Each
subnet must be unique. Subnet configurations that overlap other configured subnets will be rejected. See
•
Internal Ethernet Switch Configuration.
Allows you to configure how Ethernet frames will be forwarded
among the front panel Ethernet ports. See
for additional information.
New configurations go into effect immediately after clicking on the A
PPLY
button and confirming the action.
8.3.3
Security Settings
This page sets the security requirements for access to the following web pages: Configuration, File Management,
Firmware Update, and Custom HTML (graphics) web pages.
•
HTTP Basic Authentication
(Web Server Password Protection)
o
No Authentication Required (Disables Password Protection)
o
Allow only the following users (Enables Password Verification)
If selected, allows user to create ‘Password List’ co
ntaining up to 16 entries. Each entry consists of a
unique Username (1-16 characters) and password (1-16 characters. The following characters may be
used in password:
a-z A-Z 0-9 ~ @ % ^ _ + = { } [ ] : , . ? /.
•
HTTPS Encryption:
Encrypts the communications with the web server when the box is checked..
Checkbox to ‘Use HTTPS Encryption’ when selected (Default = Disabled)
When [A
PPLY
] button is pressed, the updated configuration parameters are saved to the database and a
confirmation message is displayed.
