PowerStation Flash Memory Replacement
2
Computer Technology Corporation
•
Keep any card in its anti-static packaging when it is not installed
in the PowerStation, and place it on a static dissipative mat when
you are working on it.
•
Wear a grounding wrist strap for continuous protection.
Disassembling the PowerStation
If you have read and understand the ESD safety precautions, you are ready
to disassemble the PowerStation. Follow these steps to disassemble the
unit:
Important
As you begin to disassemble the unit, you will encounter several
different screw sizes. When you reassemble the PowerStation, be
sure to replace the same size screw in the same location as the one
that was removed. Failure to do so could result in damage to the unit.
1.
Turn off power to the unit.
2.
Disconnect the unit from the power source.
3.
Remove the unit from its enclosure, if installed.
4.
Place the unit on a static dissipative mat in a location free from dirt and
moisture and protected against static discharge. You must also wear an
ESD wrist strap connected to a good known earth ground.
5.
Place the unit on its display, and remove the screws securing the back
cover.
6.
Remove the back cover from the unit.
Removing a Flash Memory Module
The flash memory modules are located on the System Support Card
located directly in front of the CPU card as you face the back of the unit.
You can also identify the System Support card as the card with the 9-pin
and 25-pin D-SUB connectors. The System Support card is shown below:
1.
Locate the flash SIMM sockets located in the upper left corner of the
