PowerStation Flash Memory Replacement
Computer Technology Corporation
A3-05197-100
Background
This document describes the procedures for replacing the flash memory on
PowerStations. The P2, P3, and P5 PowerStations come equipped with
flash memory in place of a hard drive. This section describes how to
remove and replace flash memory for these units.
This procedure requires the following tools:
•
Slotted head (#2) screwdriver
•
Phillips head (#0) screwdriver
•
Quarter inch nut driver
Important
The PowerStation uses special flash memory SIMM modules that
are available from CTC. Using flash memory modules from a
different source will cause unreliable memory storage. Also, CTC
cannot guarantee the integrity of backup operations.
Before you begin removing or replacing the flash memory, be sure to back
up any important data or Interact projects on the existing flash disk. Refer
to the Interact Project Manager User Guide for details on backing up
Interact projects.
Electrostatic Discharge Precautions
Modern integrated electronic devices, especially CPUs and memory chips,
are extremely sensitive to electrostatic discharges (ESD) and fields. Before
you disassemble the PowerStation, be sure to follow these simple precau-
tions to protect you and the PowerStation from harm resulting from ESD.
1.
To avoid electric shock, always disconnect the power from the Power-
Station before you remove the backshell cover or separate the back-
shell from the front panel. Do not touch any components of the CPU
card or other cards while the PowerStation is on.
2.
Disconnect power before making any hardware configuration chang-
es. The sudden rush of power as you connect a jumper or install a card
may damage sensitive electronic components.
3.
Only handle internal components in an ESD-safe location using appro-
priate grounding methods.
•
Always ground yourself to remove any static charge before you
touch the CPU card.
•
Be particularly careful not to touch the chip connectors.
