29
CHAPTER 3
INTRODUCTION TO CLI
interface GigabitEthernet 1/1-5
exit
interface GigabitEthernet 1/1-3,5,7
flowcontrol on
exit
show interface * status
disable
show clock detail
show dot1x
show history
3.6.9 Help
Help command can be issued in User, Exec, and Global Config mode to get a hint message describing how to use
“show” command to get help from CLI.
# help
Help may be requested at any point in a command by entering
a question mark '?'. If nothing matches, the help list will
be empty and you must backup until entering a '?' shows the
available options.
Two styles of help are provided:
1. Full help is available when you are ready to enter a
command argument (e.g. 'show ?') and describes each possible
argument.
2. Partial help is provided when an abbreviated argument is entered
and you want to know what arguments match the input
(e.g. 'show pr?'.)
3.6.10 Logout
To close an active terminal session, issue the “logout” command in User or EXEC mode.
(config)# exit
# logout
Press ENTER to get started
# disable
> logout
Press ENTER to get started
3.7 Commands in User Mode
When you successfully login in Command Line Interface, you are in EXEC Mode (prompted with “#”). To enter
User mode, issue “disable” command after # prompt. Then you will be directed to User mode with “>” prompt.
Username: admin
Password:
#
# disable
>
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
