192
CHAPTER 3
INTRODUCTION TO CLI
Show:
# show voice vlan [ oui <oui> | interface ( <port_type> [ <port_list> ] ) ]
3.9.47.19 (config-if)# switchport voice vlan mode
Syntax:
(config-if)# switchport voice vlan mode { auto | force | disable }
Explanation:
Configure Voice VLAN mode on a per port basis.
Parameters:
auto: Enable the Voice VLAN auto detection mode. When voice (VoIP) traffic is detected on a port, the port will
be added as a tagged member to the Voice VLAN. When Auto mode is selected, you need to further decide a
method for detecting voice traffic in “Discovery Protocol” field, either OUI or LLDP (802.1ab).
force: Enable Voice VLAN feature on a particular port.
disabled: Disable Voice VLAN feature on a particular port.
Negation:
(config-if)# no switchport voice vlan mode
Show:
# show voice vlan [ oui <oui> | interface ( <port_type> [ <port_list> ] ) ]
3.9.47.20 (config-if)# switchport voice vlan security
Syntax:
(config-if)# switchport voice vlan security
Explanation:
Enable security filtering feature on a per port basis. When enabled, any non-VoIP packets received on a
port with Voice VLAN ID will be discarded. VoIP traffic is identified by source MAC addresses configured in the
telephony OUI list or through LLDP which is used to discover VoIP devices attached to the switch.
Negation:
(config-if)# no switchport voice vlan security
Show:
# show voice vlan [ oui <oui> | interface ( <port_type> [ <port_list> ] ) ]
3.9.48 (config)# tacacs-server
3.9.48.1 (config)# tacacs-server timeout
Syntax:
(config)# tacacs-server timeout <seconds>
Explanation:
The time the switch waits for a reply from a server before it retransmits the request.
Parameters:
<seconds:1-1000>: Specify a value for timeout. The allowed timeout range is between 1 and 1000.
Negation:
(config)# no tacacs-server timeout
Show:
# show tacacs-server
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
