159
CHAPTER 3
INTRODUCTION TO CLI
3.9.39.25 (config-if)# qos ingress trust dscp
Syntax:
(config-if)# qos ingress trust dscp
Explanation:
Enable DSCP Classification of QoS for specific interface.
Negation
: (config-if)# no qos ingress trust dscp
Show:
# show qos
# show qos [ { interface [ ( <port_type> [ <port> ] ) ] } | wred | { maps [ dscp-cos ] [ dscp-ingress-translation ]
[ dscp-classify ] [ cos-dscp ] [ dscp-egress-translation ] } | storm | { qce [ <qce> ] } ]
3.9.39.26 (config-if)# qos ingress trust tag
Syntax:
(config-if)# qos ingress trust tag
Explanation:
Enable VLAN tag Classification of QoS for specific interface.
Negation
: (config-if)# no qos ingress trust tag
Show:
# show qos
# show qos [ { interface [ ( <port_type> [ <port> ] ) ] } | wred | { maps [ dscp-cos ] [ dscp-ingress-translation ]
[ dscp-classify ] [ cos-dscp ] [ dscp-egress-translation ] } | storm | { qce [ <qce> ] } ]
3.9.39.27 (config-if)# qos storm
Syntax:
(config-if)# qos storm { unicast | broadcast | unknown } <rate> [ fps ]
Explanation:
Configure broadcast storm control rate for QoS on the selected ports.
Parameters:
{ unicast | multicast | broadcast }: Specify the storm type that you want to configure.
{ { <rate> [ kfps ] } | { 1024 kfps } }: User-define storm frame rate or set storm rate to 1024 kfps.
Example:
The following example sets broadcast storm control for QoS to 1024 kfps.
Negation
: (config-if)# no qos storm { unicast | multicast | broadcast }
Show:
# show qos storm
# config t
(config)# interface GigabitEthernet 1/1
(config-if)# qos storm broadcast 1024 kfps
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
