9
1 . Strip outer jacket of cable back 1¼ in . and remove all of the shielding .
2 . Separate the internal wires from the shield and twist the shield .
3 . Strip red and black insulation back ¼ in .
Figure 8. Bottom View
Figure 7. Front View
Figure 9. Stripped Wire
(-) Common
Shield/Drain wire
(+) Signal/Power
4 . Locate the appropriate plug, identified by channel number, remove the plug and
install the wires using a small flathead screwdriver . Push plug back into location .
Orientation is as follows:
a . Red insulated conductor wire is connected to (+) .
b . Black insulated conductor wire is connected to (-) .
c . Shield drain wire is connected to ground (GND) .
d . Depress selected position button to open terminal for respective wire (may
require a mini flat head screwdriver).