CTC Union ICR-4103 Series, User Manual

Page: 66 / 155

66
CHAPTER 3.
WEB CONFIGURATIONS
3.8.2 IP RIP
This section allows you to configure RIP and select the mode from Disable or Enable. The default
is Disable.
Note:
RIP (Routing Information Protocol, RFC 2453) is an Interior Gateway Protocol (IGP) and is
commonly used in internal networks. It allows a router to exchange its routing information
automatically with other routers, and allows it to dynamically adjust its routing tables and adapt to
changes in the network.
System > Static Route
Item Description
Mode
The setting is open for full network. Select from Off or On.
Status
Destination
Show the status of destination from the setting section.
Gateway
Show the status of gateway from the setting section.
Interface
Show the status of interface from the setting section.
Protocol
Show the status of protocol from the setting section.
IP Routing > RIP > General
Item Description
General
Mode Select from Off or On to open or close RIP function.
Redistribute local routes Select from Off or On to open or close redistribute local routes.
Redistribute connected
routes Select from Off or On to open or close redistribute connected
routes.
Redistribute OSPF routes Select from Off or On to open or close redistribute OSPF routes.
Redistribute BGP routes Select from Off or On to open or close redistribute BGP routes.