CTC Union GSW-1005MS, User Manual

Page: 33 / 58

Chapter 3 Configuration and Operation
33
3.3.5.4 SSH
Configure SSH on this page.
Mode: Indicates the SSH mode operation. Possible modes are:
* Enabled: Enable SSH mode operation. (default)
* Disabled: Disable SSH mode operation.
note:
SSH is preferred to Telnet, unless the management network is trusted. Telnet passes authentication credentials in
plain text, making those credentials susceptible to packet capture and analysis. SSH provides a secure authentication
method. The SSH in
IFS/IGS803 uses version 2 of SSH protocol.
3.3.5.5 HTTPS
Configure HTTPS on this page.
Mode:
Indicates the HTTPS operation mode. When the current connection is HTTPS and HTTPS mode operation is
disabled, web browser will automatically redirect to an HTTP connection. Possible modes are:
* Enabled: Enable HTTPS mode operation.
* Disabled: Disable HTTPS mode operation.
Automatic Redirect: Indicates the HTTPS redirect mode operation. It applies only if HTTPS mode "Enabled" is selected.
Automatically redirects HTTP of web browser to an HTTPS connection when both HTTPS mode and Automatic Redirect
are enabled. Possible modes are:
Enabled: Enable HTTPS redirect mode operation.
Disabled: Disable HTTPS redirect mode operation.
3.3.5.6 Access Management Configuration
Configure the access management table on this page. The maximum number of entries is 16. If the application's type
matches any one of the access management entries, it will be allowed access to the switch.
Mode: Indicates the access management mode operation. Possible modes are:
* Enabled: Enable access management mode operation.
* Disabled: Disable access management mode operation.
Delete: Check to delete the entry. It will be deleted during the next save.
VLAN ID: Indicates the VLAN ID for the access management entry.
Start IP address: Indicates the start IP address for the access management entry.
End IP address: Indicates the end IP address for the access management entry.
HTTP/HTTPS: Checked indicates that the matched host can access the switch from HTTP/HTTPS interface.
SNMP: Checked indicates that the matched host can access the switch from SNMP.
TELNET/SSH:
Indicates that the matched host can access the switch from TELNET/SSH interface.