CTC Union EcoAir 500M, Installation And Maintenance Manual

Page: 8 / 44

8 CTC EcoAir 510M 230V 1N~
Checklist
The checklist must always be completed by the installation engineer
• If service is needed, you may be required to provide this document.
• Installation must always be done according to the installation and maintenance instructions
• Installation must always be carried out in a professional manner
Following installation, the unit must be inspected and functional checks performed as
indicated below:
Pipe installation
† Heat pump filled, positioned and adjusted in the correct manner according to the
instructions.
† The heat pump is positioned so that it can be serviced
† Capacity of the charge/radiator pump (depending on type of system) for the flow required.
† Open radiator valves (depending on type of system) and other relevant valves.
† Tightness test
† Bleed the system
† Check proper operation of the requisite safety valves
† Action taken to deal with condensation water
Electrical installation
† Power switch
† Correct tight wiring
† Requisite sensors fitted
† Heat pump activated and started
†
Accessories
Customer information (adapted to the relevant installation)
† Start-up with customer/installer
† Menus/controls for selected system
† Installation and maintenance manual supplied to the customer
† Check and filling, heating circuit
† Information on fine adjustments
† Alarm information
† Functional test of safety valves fitted
† Register your Installation Certificate at ctc-heating.com.
† Information on procedures for fault registration
________________________________________________ ____________________________________________
Date/Customer Date/Installer